Remix: Xbox Controller Holder with Pushfit Mounts for Multiboard (Based on Sof)

This is a remix of the Xbox Controller Holder by Sof, modified to work seamlessly with the Multiboard system using Moderate Weight Bearing Snaps.

I integrated the official Multiboard pushfit adapters directly into the model and adjusted their spacing from 50 mm to 25 mm for a more compact and practical fit. The adapters are slightly rotated, so the entire model prints flat on the bed – no supports needed.

It’s a clean and efficient solution for mounting your Xbox controller to a Multiboard wall system, with easy snap-on/snap-off functionality. Perfect for organized, modular setups in your gaming or workspace.

Features:

Compatible with Moderate Weight Bearing Snaps from Multiboard

Integrated the original Multiboard pushfit mounts.

Reduced to 25 mm spacing for tighter layouts

No supports required – prints flat (also as the model from Sof)

15% gyroid infill used (FDM, 0.2 mm recommended)

Important:

Moderate Weight Bearing Snaps not included – available via the Multiboard system

Ensure proper printer calibration for accurate snap fit

Let me know if you have any feedback or questions – happy printing!

Added the original Stepfiles of Multiboard pushfit adapters to the model to fit perfectly with the Moderate Weight Bearing Snaps. (For me the fit on Sof's model was too lose)

Reduced Adapter Spacing: The distance between the pushfit mounts was changed from 50 mm to 25 mm for a more compact layout.