Blink Bird Bath birdbath outdoor

From the original model - 15% gyroid infill as a MINIMUM requirement.

This is a remix of Blink Bird Bath birdbath outdoor Remixed by LiamOD MakerWorld: Download Free 3D Models, but is sized for the Blink4 outdoor camera. It uses the same design but now has a removeable/interchangeable bath area. You can now place the camera in and not have to worry about taking the whole thing apart for cleaning. The attached image is on a lower setting to save battery as well as isnt placed completely straight, so it is now more of a drinking than a bathing area. Lol. Oh well, I still get to enjoy the birds and they get clean/fresh water. 

Hopefully you enjoy it as much as I have!

***** Update: There really wasn't a whole lot of issue with the first model. However, squirrels were using the dish as a dive board when running away. This would take out the bowl and dump seed everywhere. The new version has a better interlocking system with a physical “bolt” to hold it together. I also adjusted the angle for the dish sit a bit flatter. Although I am still only filling the water to about 20/30% to allow stuck bugs/insects a way to escape. There are also two new versions of the dish itself, besides the bolt hole, I have one with a small hole in the middle. This is just for water drainage. If desired, a small mesh screen, or something wildlife safe, can be added to stop seed from falling through.

The original is for a different blink camera. This is for a blink4 outdoor camera as well as the bowl is separate/interchangeable.