A320 landing lever for simulation

Bring realism to your flight simulator with this A320 landing gear lever replica.

Built using just two limit switches, a few screws, a spring, and an Arduino
(Mega, Mega Pro Mini, Pro Micro, Uno, or Nano), it’s simple and effective.

Fully compatible with Mobiflight, it works seamlessly with:
MSFS 2020/2024, P3D, FSX, FS9, and X-Plane 9 to 12.

You can even add an LED to illuminate the gear position arrow for extra immersion.

Includes STL and STEP files, so you can modify or adapt the design to fit your needs.

Printed using PLA for most parts and a small amount of PETG for the lever.

An easy-to-build, highly immersive solution for any home cockpit with a detailled manual a the end of this page.

For more info about Mobiflight: https://www.mobiflight.com/en/index.html 

For this project, you will need:

• 2x HV-156-1C25 end switch // Amazon links
• 1x A compatible Arduino board // Check which ones are compatible with Mobiflight
• 2x Ball bearing MR95ZZ 5x9x3mm // Amazon links
• 1x compresion spring Ø9 mm × 18 mm L // Amazon links
• 18x m3 nut // Amazon links 
• 16x m3 x 10mm countersunk head screw // Amazon links 
• 7x m3 x 16mm countersunk head screw // Amazon links
• some dupont connector or other cable 
• Note: you can modify the document to add insert instead of nut

All this project can be PLA printed exept for this 3 part that need to be PETG printed :

1. A320 landing gear Stick
2. A320 landing gear Stick_Pivot
3. A320 landing gear Stick_End

Optional material :

• 2 x 5cm of 10mm x 5mm brush strip // Like this one
• 1x red led for illuminating the arrow // Amazon links
• 1x small piece of red tinted plastic // Amazon links

Instruction links :

https://instructions.online/?id=19131-a320

or instruction qr code

Note: Not all the provided information are guaranteed to work perfectly for this project — please check compatibility before purchase.