AC Power Splitter

AC Power Cord splitter (Kettle Cord) mk1

This was part of my 3D Printer enclosure projects to tidy up the cables on the back of the enclosure.  

Uses a standard ‘chocolate bar’ electrical connector

This design comes with: 

The body of the splitter

clip-on top (screwless)

a cable-hole top that can be screwed on (3M).

a hole plug in case you don't need all 4 extensions.

Cable hole diameter: 7mm

Blender 4.2 Used.

Note: I tried printing this with ABS first.  However it's -7 degrees (C) outside so it warped.  I had little patience so I printed it instead with PLA+ (the print in photo).  ABS printed better (except for the warp) but, I think it might have something to do with the print settings not being adapted to the new enclosure yet - I will play with the settings a bit more.  Anyway: PLA worked fine although I still believe ABS would be better.