Tongue (foot) for Leveling the Switch 2 JoyCon2 Grip

I sometimes like to play with my controllers laying on a table or desk, and I didn't care for the natural angle the Switch 2 JoyCon2 Grip leans down and away. 

After modeling a few variations, I also realized this could look like a tongue, which brings back a little of that “switch joycons look kinda like a puppy” vibe, and I think this makes it even cuter!

Designed for use with double sided tape or adhesive mounting pads like Command strips, this fits under the small cross bar in the back as a cantilever. A small recess is set on the back for further expansion of the idea with a wall hanging solution. (granted, that breaks the theme, but maybe you see the controller as more of a fish, like a flounder).

All supports are pre-built into the model. Should snap out easily, with pliers and a metal spatula tool at most.

Included 3mf and bgcode files are configured with "fuzzy skin" enabled, to further sell the idea of taste buds.

Print in whatever color you like!