Dragon_Burner P.I.N.D.A. Cowl

Simple P.I.N.D.A (pinda) mount for your DragonBurner toolhead. The Y range loss is quite minimal, I think it's around 1mm or less.

The PINDA is secured with two M2x12 “self tapping” screws through the holes in the rear of the mount. Once it's adjusted how you like, there is room for a zip tie.

 Here is my Klipper config:

[probe]
pin: ^gpio25
# TZ V6 2.0  (formbot kit) offset
x_offset: 30.922
y_offset: -15.67
samples: 3
speed: 100
samples_tolerance: 0.010
samples_tolerance_retries: 4

[bed_mesh]
speed: 100
horizontal_move_z: 5
mesh_min: 31,5
mesh_max: 110, 104
#mesh_pps: 2,3
move_check_distance: 3.0
split_delta_z: .01
probe_count: 3,3
algorithm: bicubic

Mount for PINDA probe on cowl