Koholint sword (Legend of Zelda, Link's Awakening)

All copyright and credit to original creator and Nintendo where applicable. 

Scaled it up to be real size 275% gives it about a 13" blade and about a 3.5" handle grip. 

I've cut it into several parts to aid in printing. 

as well as added holes for Dowels. 
you'll need  ¾" and ½" dowels to assemble, as well as one screw. 
probably some glue as well. 

due to thickness constraints, you'll need to find a way to sand, flatten, or remove two opposing sides of the ¾" dowel. – this will also help keep things straight… (as if the two ½" dowels on either side wouldn't help in that regard…) 

Enjoy!




*** 08/18/25***
Finally got around to printing it.
prints well :)


I used some concrete and put it in the pommel jewel, for some counter weight. not sure it did much. but I tried :P

everything was a bit of a tight fit, so I did end up reaming out the holes as well as sanding the dowels pretty good as well. before assembly and final glue up.

I hot glued the ¾ inch dowel to a piece of scrap wood, just along the top, using the table saw fence to keep everything perpendicular. then I was able to safely cut the sides off. 
 
 

Also I made a display for it! 
find the Plinth Here.