Printed in Translucent Orange Sunlu PETG (edited)
Buddy3D camera for CORE One printed parts
Buddy3D Camera for Prusa CORE One printed parts
225
610
8
6447
updated
September 23, 2025
Makes
Comments
Worked perfectly. Prusa prints in PCCF which I did not have so used ABS.
@CeptoRIder Is this the original design or a remix like mine to avoid the collision with the vent of the One L? (edited)
@Kachidoki it is yours. Maybe I posted the Make in the wrong spot.
View one more comment
This is such a minor complaint to have- but- this model isn't parametrically constrained at all- the angles of things are all off- none of the sides of the hexagon are parallel. I was gonna modify it, but I can't really because of this. You also can't really unsee it once it's been pointed out.
I have a humble request, if the PR could release the camera housing where the camera is rotated 90deg ?
Right now the camera is capturing a lot of areas im not interested but some of the prin area is not captured at all. totating the cam would probably fix it all.
Is this the same as the one Prusa now sells preinstalled as the dedicated Core One Buddy Cam? I have that and I don't like the view angle. It's tilted funny and aims too far to the right (speaking from the camera's point of view, so I'm saying the camera is looking too far to its right). I tried sticking some more magnets behind one side as a shim, but it's sketchy doing that. I'm hoping for a better viewing alternative or perhaps I'll have to do it myself.
Printing all the parts to convert my Buddy3d Camera to core one. Where do we find the part that I have pointed out? Is it available somewhere to purchase? What is it called?
@EC_2912 photo resistor lens for low lighting
@SpencerLamb_594617 any idea where to find one?
View 4 more comments
love the design! Printed in Jessies premium petg neon yellow, 15% gyroid infill, and .25 structural. (edited)
@adironick_3294882 do you know where that small lens came from under the camera lens? Did it come with your buddycam? Some users don’t seem to have that installed.
@SpencerLamb_594617 This was made from a disassembled buddy cam instead of a re-shelled core one version.
View one more comment
What size magnets and what hardware and sizes? Thanks for any help
@adironick_3294882 In original camera is used 4pcs of 10x6x2mm neodym magnets. But I don't know if the magnet strength is N38 or N42.
@chipmen_174476 Stronger the better, I tend to put the strongest one that'll fit so I don't have to worry about it not holding.
View one more comment
It would be great to get a wedge or something to adjust the angle of the camera upwards slightly so I can see the back of the build plate when its high up