Sticky Snake (20% smaller)

This model is a smaller version of the "Sticky Snake" model.

Like the full-sized version, this model also comes in two versions: one with magnet slots and a normal snake.

Click here to download the Sticky Snake model in original size.

It's important to know that the version with magnet slots has less flexibility than the normal version.

Why Did I Create a Smaller Version?
The original version can be printed larger (though only the normal snake; the magnet-slotted version cannot be resized because the slot dimensions would change) However, it's not possible to print it smaller, and the parts aren't optimized for printing below the original size. With this new version, you can have Sticky Snake printed at 20% smaller than the original size.

 
For the original model you needed magnets in three different sizes, but for this model, you only need 4x1.5mm magnets.
 

The magnet slots have a tolerance of 0.2mm. You can simply press magnets into place with your finger. The connections are very close together, so don't print at high speeds, as this will reduce the tolerance of both the connections and the magnet slots. if your first layer is too close to the build plate, you might need to clean the slots openings.