Angled Spacer for Stax SR 207

A modified version of my spacer for the Stax SR-207.
The comfort was good, but I was never fully satisfied with the change in soundstage , it felt more distant and lacked the precision of the original setup.

This second model addresses that by adjusting the spacing: instead of a fixed spacing, it’s angled front to back.
Just like the original version, it uses the stock screws and is easy to install and remove. 

Spacer Size :
10mm to 5mm
10mm to 3mm
15mm to 3mm (the one i used)

Print settings:
Material: PLA Black matt
Layer height: 0.16mm
Wall loops: 4
Infill: 25% (gyroid pattern)