Cabinet Leveling Foot - Small

Update  Aug 20 2025

In response to comments about the fit of the threads I am now including renders with increased thread tolerance gap. You can also make custom adjustments to the fit by editing the value of the ThreadToleranceGap parameter in the f360 file. Any feedback about thread fit would be helpful. Please mention the type of filament used as well as the thread tolerance gap size used (0.2, 0.4, 0.6mm.) In most cases going with the larger tolerance gap is a safer bet for your first print. 

New version 1.1  July 27 2025

• The 4 screw channels have been extended to decrease the chance of cracking along layer lines in the case of an over tightened screw.
• Foot radius decreased by 1mm for easier adjustment in recessed areas.
• Foot insert is now 1mm taller to provide more padding
• A new Tall Foot Insert is included which adds an additional 1mm of height.
• A new No Insert version of the Foot is included
• Feet now have a 3/8 square socket so they can be turned with a 3/8" ratchet or extension.
• Four new Wrenches are included to help adjust the height of the feet
• Not compatible with v1.0 parts.
• Untested. Good luck.
• A zip with the original v1.0 files is included.

Instructions

Glue the TPU insert into the bottom of the foot using CA glue or hot glue.

Be careful not to over tighten screws or the bracket may crack along layer lines - see photo. (New v1.1 addresses this.)