Floppy Whale Shark - Articulated whale shark

It's a floppy whale shark!

Let it swim from your dreams out onto your print bed, then flex on your friends as you show them the coolest thing in the world! (The coolest thing in the world is the floppy whale shark you just printed, in case you were wondering)

Printing Instructions:

The 3mf file provided was created using Bambu Studio and will have the following settings configured.

• Layer height: 0.16mm
• Wall loops: 3
• Supports: Nope!

Make sure you have your build plate nice and clean to avoid adhesion issues. Either clean it with an ammonia based cleaner like Windex or clean it with high quality dish soap and warm water. IPA also helps, but not guaranteed to work.

Thank you for your time and consideration on this matter.

For those who have joined my club at the “Obsessor” tier or have subscribed to my commercial membership on Patreon, prints of this model can be used for commercial purposes.

Feel free to join my discord for additional support, questions, or suggestions!