Lithophane Lamp with Lighted Backsplash

This is a lithopane holder lamp.

To generate a lithopane that fits go to https://lithophanemaker.com/Curved%20Lithophane.html and use the following settings:

• Height: 125
• Angle: 90
• Maximum Thickness: 3.2
• &Make sure you upload a 4:3 aspect ratio landscape photo

Settings not mentioned above shouldn't matter much for fitment.

Supplies Needed:

• 1x of every STL here, printed
• 1x printed lithopane that fits

For the light hardware, you can get creative. The following is just what I used:

• 1x 0.5in section of 1/8-IP thread 'nipple' (it's what's on the package)
• 1x Tapped 1/8-IP Hex Nut
• 1x E11 Socket /w a receiver for the 0.5in 1/8-IP nipple on the bottom (fairly standard lamp hardware)
• 1x 50-Watt Equivalent Bright White (3000K) T4 Mini Candelabra E11 Base Decorative LED Light Bulb
• 1x 8ft power cord
• 1x feed-through on/off switch

I've also included the STEP file in case anyone wants to further modify this lamp

Print Settings

Printer:

Seckit-Go

Rafts:

No

Supports:

No

Resolution:

0.25

Infill:

13% gyroid

Notes:

You may want to play with the extrusion thickness & layer height settings a bit to make sure gap fill isn't taking up an inordinate amount of time.