Toilet Paper Cover

In the interest of full disclosure this was one of my very first designs and prints when I got in to 3d printing. 

My cat kept destroying entire rolls of toilet paper whether it was hung the correct or incorrect way. I would wake up to entire rolls shredded on the ground to the point where I stopped using the holder dispenser.

I got tired of that so modeled a cover that would fit over my in-the-wall dispenser with a slit cut in it for the toilet paper to dispense from.

You would likely need to re-size this to match your dimensions. It would also likely benefit from being cut in to further pieces to avoid having to use so much support. You will also likely be able to make a far better looking one than mine. Do the supports on the inside if you can.

UPDATE: Not one cat-related toilet paper incident since implementing this!

Print Settings

Printer Brand:

Dremel Digilab

Printer: 

3D20

Rafts:

No

Supports: 

Yes

Resolution:

.40

Infill: 

30%

Filament: White PLA

Glue the two haves together.

Category: Bathroom