Printable Mini Fridge Door for Voron 0.2 V0.2

Printable Mini Fridge Door for Voron 0.2 V0.2

This is my budget version of a mini-fridge door. It doesn't require any extra extrusions and reuses some leftover hardware you might have from an Ender 3/5.

Design considerations:

• fully 3D printable on a 250mm x 250mm bed
• minmal extra hardware
• reuse the existing panels from a 0.2 kit
• create a better seal to minimise heat losses (untested, unverified)

Requirements/BOM:

• Voron 0.2 with 80mm tophat
• 30 mm tophat extension https://www.printables.com/model/586916-voron-02-tophat-panel-extension-remix & https://www.printables.com/model/526265-voron-02-tophat-spacer-incl-panel-extension/files
• 4 qty of M5x20mm BHCS
• 4 qty of M5 ID 8mm OD 7mm height bushing (found on Ender 3/5, used to space the V-wheels)
• 2 qty of M5 nylon lock nut (standard M5 nut could work untested)
• ~20 qty of M3x5mmODx4mm height heat set inserts
• 8 qty 6mm diameter x 3mm height magnets
• 10 qty of  M3x8mm SHCS (to attach the hinges and latch)
• 2 qty M3x16mm SHCS (to attach the handle)
• All the M3 hardware to attach the front panel
• 339mm x 209mm x 3mm Acrylic/Polycarbonate panel (I chose PC)
• 3mm foam tape
• 1mm foam tape

I've lost the 3D design file for the Hinge-Lower part, only the .3mf is available.

All 4 panel clips are uploaded as a single .3mf because I got lazy.

I hope the community can improve upon the design. These are the current limitations I'm aware of.

• Not the greatest sealing, especially in the corners on the right hand side.
• Gaps at the front idlers since the panel clips on the side 3mm panels are removed.
• A little bit of a collision between the latch and the modified handle (the radius was increased to fit the 5mm bolt)

Thanks!

Changes:

• designed printable “extrusions”
• remodelled the hinges and handles to accept leftover M5 hardware
• space for M3 heatset inserts to attach a front panel to create an air gap
• combined parts to mount the front panels