Prusa Core One Dust Protector (remix)

Remixed the rear dust protectors from @dancan13f full set (awesome, love them) so they don't cover the entire back vertical surface, and can fit an 8mm magnet.  Replaced the vertical bars with a low ramp so anything that falls should roll/slide to where it can be retrieved.

Also included are my remixed side protectors as one solid piece with 8mm magnet insets.  NOTE:  The side protectors are too large for the bed of a Core One (I printed mine on an XL).  If you don't have a larger print bed use the originals by @dancan13f.

Check out my other Prusa Core One Accessories:

https://www.printables.com/@Jupera/collections/2441654

Replaced full vertical bars on rear panel protectors with a low ramp so anything that falls should roll/slide to where it can be retrieved.  Also remixed the side protectors as one solid part.  Removed original magnet indents and added indents for 8mm magnets.