Pedestal Fan Feet Replacement

This is the design for the feets of a Facto pedestal fan bought at Reno Depot (owned by Lowe's now). It's a house…
1
12
0
478
updated February 13, 2022

Description

PDF

This is the design for the feets of a Facto pedestal fan bought at Reno Depot (owned by Lowe's now). It's a house brand, so it's likely sold under other named.

The part that inserts into the tube is 24mm.

Including the Fusion360 file if anyone would like to make changes.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

Yes

Resolution:

0.3mm

Infill:

20%

Filament: Flashforge PLA+ Black


Notes:

Recommend printing the part with the smaller end down to get a nicer finish on the outside section.

Support are recommended, but it should print without them (did not try).

On the PrusaSlicer the default "0.30mm DRAFT" profile was used at 20% infill.

Category: Replacement Parts

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License