This clip lets you stack your drums on top of each other whilst protecting the drum skin.
Lets you specify parameters for drum diameters, rim widths and depth.
You can add optional magnets to make installation a little easier, as they tend to dip into the middle without the upper drum installed.
I included the files for my setup, without the holes for magnets.
I printed them out of PETG on a .6mm nozzle with .3mm layer height, 3 Perimeters.
Infill shouldnt matter too much, supports should not be needed (only short bridges).
Just keep in mind that there are small areas that might not stick to the printbed without a rim.
The author marked this model as their own original creation.
