Label holder for Ikea Blomning tea/coffee container

This label holder for the Ikea Blomning tea or coffee container will print with no supports, but a brim is recommended for stability. It's 7cm wide and 5cm tall. The back is very thin, just enough to have you apply double sided tape to stick it on the container.
In this example .4mm paper is used which is rather thick but you can use thinner or thicker if needed, it has room to easily add or remove the label.

Things to take note of:

• The back is very thin, so it might not connect 100% but who cares, it's the back and you'll never see it. It works :)
• It will print with some stringing. Just pull it off and then carefully burn it off
• It is advisable to use brimming. Just pull and/or cut it off and burn it slightly for a clean result.