2.5inch Three Jaw Chuck

awesome print!.. pretty fast allso.. maybe like 2hours. well, with PLA 5perimeters and 30% gyroid... without brim or any supports needed. the tolerances seem too large.. but if you watch the photos.. maybe its cause i didnt calibrate anything on my printer before i printed the chuck.

only the clip holding it together doesnt hold it that well... if you tighten in too much it just disassembles..

i will make new clip and file the groove for it bitdeeper
then i just need to print some holder for it and i can hopefully make it work together with dremmel as cutting tool

Thank you! Perfect model!
Printed in PLA with 0.4 mm nozzle, 0.2 mm layer height, 50% infill.
I'll use it as a filament spool mount with bearing attached

Printed in Elegoo PLA on my Centauri Carbon. 0.2mm layer height, 3 perimeters, 70% cubic infill.

Great Chuck. Works well and is smooth right off the build plate. Picture has a remixed base I added later.

Nice model, was perfect for what I was doing :D

Not for serious work, Overall a good model

Top danke funktioniert einwandfrei.

super danke genau was ich gesucht habe

these really helps me finish my projects! awesome creator!

nice model need big one

Works great. No support needed.