Low Rider V2 - 4" dust collector adapter

This allows a 4 inch dust collector hose to be attached to a low rider 2. I had originally intended to drill a couple holes in the 'wings' and bolt some velcro strap on, but it seems to friction fit on the machine fine for me without the need for that. There is intentionally some 1 to 2 mm gaps so that you can add some weatherstripping to make things airtight.

Performance on this is really good.. seems to do a much better job than my shop vac and way less noise.

This required you re-mount your router base 180 degrees on the plate. It makes it so you can't access the button to change the bits easily but this wasn't a problem for me since I take the router out to change bits. Also, make sure your router height is set so the collet is flush with the bottom of the plate and not hanging down. This will allow more airflow and also if you lose Z power I think it's safer since the collet can't rub on your material and potentially start a fire.

Print Settings

Supports:

Yes

Resolution:

0.25mm

Infill:

10%

Filament:

black