SFP Holder/Lid

If you work in tech, you probably know what an SFP is.  And if your job is like mine, you end up with over a hundred of these little buggers sitting in a plastic bin.  And you can never find the right one when you need it, either!

My solution: a simple box and lid that'll hold any 25 SFP's you want, a nice flat top on the lid so you can put a label on it, and a friction fit so that they don't accidentally fall out when you grab the box and run back to the server room.

It's not fancy, but it gets the job done and is relatively easy to print.  I used Prusa slicer default settings for PLA fast and only changed infill to 10%.  On my CoreOne it took less than 7 hours to print 2 at the same time.