Butane Lighter / Torch Case - Base Warehouse Australia model.

Lighter purchased in Base Warehouse Australia:

https://thebasewarehouse.com.au/products/lighter-gas-blow-torch-refillable-freedom-designs

If you have this model (or very similar looking model) of Butane Lighter, this case perfectly grips the lighter and keeps it secure.

I have left 5x5mm magnet holes in the STL, but you can mess around with the STEP file to easily remove them or add your own.

Recommended to print the insert in PETG to allow easier flexing when gripping the lighter. PLA is very likely to snap off within a few tries.

No supports needed. Remember to turn them off if you're insetting magnets.

Increased the size to accommodate the insert.