KODAK PIXPRO WPZ2 Camera TPU Lens Cap

I was disappointed to find that my new shockproof camera did not include a lens cap, so I made one.

This is designed to latch onto the back of the flash, so it will likely not work unless printed in some flexible filament like TPU.  It is possible that there is enough tolerance for a harder material to work though, but I have not tried…

A TPU strap is also part of the print, so the cap stays attached to the camera.  A model without the strap is also present, as well as a model with just a cord attachment point near the cap.

I printed in TPU with 0.2mm layer height.  No supports are needed.

I did see that a similar model from @Zuippe_1303877 exists here, but I created my own design from scratch.  Compared to that model, this one:

• Latches to the camera
• Includes a strap
• Is more form-fitting (follows the taper of the lens and the flash)