Blinder holder

Two of these small plastic clips hold the blinders down. Good especially if you have the blinders on a door because otherwise the blinders will swing and potentially break.

Naturally this kind of small parts break in due time so here is a new version. Originals where poorly designed to say the least. There is a piccy of original broken one too.

Both sides are symmetric so just 2x print the same part in case old ones are broken.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK2.5

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

I used 0.2 layer

Infill:

I recommend adding 100 infill to certain parts. See the slices file .

Filament Material:

PLA

Notes:

PLA will not last well so use ABS instead. I just happened to have PLA so it will last 1-2 years in the sunshine ... maybe...