Voron 0.2 OV5647 Raspberry Pi Camera and Thermistor Mount

I wanted a single bracket to hold a camera and a chamber thermistor, along with the camera being on the right side - closer to the Pi. 

Camera is set pointing down at 10 degrees for best visibility.

Use M2x8 (or shorter) self tapping for camera. Thermistor should interference-fit snugly into the slot.

This is designed for the (older and cheaper) OV5647 Raspberry camera.

30cm flexible cable recommended for the camera.

Standard Voron print settings, 0.2mm layer height recommended. STL is oriented correctly for printing.

Tolerances were perfect for me printed in Polymaker Galactic Grey ASA, let me know if yours aren't.