Timelapse Test Print ( I did it woooo)

This is a test print I made up to test out a timelapse set up that I had.  I spells out the message " I did it Wooooo" 

See the timelapse video below for the result.  

I referenced the Prusa blog on how to make a timelapse set up, (https://blog.prusaprinters.org/how-to-create-beautiful-3d-print-timelapse-videos_29743/)

but rather than modify the printer in anyway I just used the modified gcode in slicer. I then used a DSLR camera and remote. I modified the remote by adding extra cables across the switch and connected it to a magnetic reed switch. When the print bed magnet moved past the sensor between layers it would take a picture.

This fun test print helped me test out a new set up, as well as try and see if I could spell a secret message inside the print for the viewing pleasure of my audience.