Loveball Piggy Bank

A Loveball version of my piggy bank.

This model is very easy to print. My only suggestions are as follows:

• Height range modifier for the bottom piece 0-7mm - use slower speeds and lower layer height
• 0.2mm Layer height for everything but the heart inserts. Do 0.08mm for those.

Assembly should be easy, just a little glue and eyeball aligning. I suggest doing a dry fit before gluing to be sure you have alignment correct.

~~ If you love the design and wish to support me or have permission to sell physical items from my designs, please consider becoming a member of my club!

If you print this, please share a make so I can see! Also, if you like this model, give it a heart! Any questions, feel free to ask in the comments and I'll do my best to try to answer.