BeeLink Skadis Mount

I was working on some cable management for my desk, which included mounting a Skadis to the back of my monitor.  I didn't have a good way to secure a mini PC I use for 3D scanning to the back of the Skadis, so I came up with this.  It allows me to attach to the skjadis with minimal hardware, while retaining the airflow for the cooling fans.

The mount can be used in either vertical or horizontal orientation.  There is a notch cut out for the power cable to pass through the holder without compressing the wire.  This is important because this model of device used a magnetic power adapter which would often work itself loose.  Keeping it captive here eliminated that problem.  The mount attaches to the PC using the existing PC mounting screws, and then the entire fixture can be attached to the Skadis using the T-Clip system. The default one might not fit all Skadis board, but the Fusion 360 file is available here: https://www.printables.com/model/256896-skadis-t-clip-system

This can be printed in any filament. I used Jesse vanilla bean PLA for this print, as some of my other Skadis accessories are printed in this material and color.  Prints are already oriented porperly on the build plate, so no pre-processing should be required.

I just used the T Clips on my model.  Not sure it's a remix or just using the clip, but I figure, I'll show it as a remix, all the same.