GR86 / BRZ Phone Mount for ESR Wireless Charger

I liked the design and incorporation of the dash curves from the original. Unfortunately, y TPU print would bounce and shake too much while driving. I tried @oddballghost print and had trouble threading into the TPU without it coming loose.

This print allows you to use stronger material (ABS, ASA, PETG) and results in a sturdier assembly.

1 M3 30mm bolt

1 M3 nut

Allows you to pass M3 bolt directly through the included curved arm of the ESR Qi2 charger (including CryoBoost). Fix the base to the dash and side of the head unit with 3m doublesided automotive tape.

Print with regular supports, block out recessed nut hole

3 walls, 20% infill for rigidity

Changed the cord hook to be open and clamp against the dash to allow for a thicker charging cord and to print with less flexible material.

Recessed a notch around the screen to allow full contact with the side of infotainment unit.

Permanently added adapter for ESR Qi2 chargers.

Added M3 bolt hole and recessed nut to increase strength, as opposed to screwing into a plastic print.