Switch 2 Wrist Strap and Game Card Holder (v2)

I first just wanted a way to keep my Switch 2 wrist straps together to toss in my bag, but I quickly realized that I could carry a few game cards along with it.

To use: 

• Slip a game card under the lip and press into the rectangular slot, use the semi-circular cutout to pivot out to remove.
• Set the lower end of the wrist strap (with the cord) into a corner, then gently press the top end (with the +/- symbols) into the other corner. To remove, pull gently from the top end.

These models have supports built in. After printing, supports should just snap off. If they are stubborn, use pliers to grab the exposed corner marked “REMOVE” (half are mirrored).

Version 2 has been redesigned to pivot in from the edge which puts less stress on the edge that presses past the bump. Cards are very secure, and locked in with either wrist strap stored in the top or bottom positions.

Designed in OnShape non-commercial license.