Case for the Adafruit Macropad w/ Right Thumb Trackpad

This is a case for the Adafruit Macropad paired with a Pimoroni trackball on the right side.

Hardware Requirements:

• Adafruit Macropad - Barebones
• Slim Rubber Rotary Encoder Knob - 11.5mm x 14.5mm D-Shaft
• 12 Mechanical Key switches ( e.g., Kailh Mechanical Key Switches - Linear Red - 12 Pack
• 12 Keycaps (e.g., Clear Keycaps for MX Compatible Switches - 12-pack)
• 4 M3x5mm screws
• Pimoroni trackball
  • Note: The trackball must be installed with the connector facing downwards. See the picture for an example of the trackball placement and screws. 
• 1 100mm 4 Pin Stemma QT Wire
• 4 M2x6mm screws
• 4 M2x0.4mm Hex Nuts

Test code for this MacroPad w/ trackball can be found here:

• https://github.com/spkane/circuitpython-macropad-trackball-tester
  • Note: You will likely want a CircuitPython editor and development environment setup.

The original README can be found here: https://www.printables.com/model/138045-adafruit-macropad-case

MAKERS: Please post a picture with comments here of any prints/makes you do from this model so that I can see how people are using it and whether you are finding success with it. Thanks!

I moved the optional trackpad from the original version to the right side and tweaked some minor things.