Festool FS-WA/90° Skadis Holder

This is a simple design to mount a Festool FS-WA/90° track square onto a ikea skadis board. It uses the skadis t-nut mounting system (Link) but is also compatible with these printed t-nuts which don't require additional hardware in addition to M3 screws. 

I used two M3 x 15mm screws and two printed M3 t-nuts to mount the track square. It's easy to install and mounts sequrely. Important: you need to enlarge the mounting holes to 3mm if you want to use M3 screws and M3 t-nuts.

Print with organic supports engabled and remove them with the tip of a knife once your print has finished. Alternatively, clean up the holes with a 6,5 drill bit. 

If you have any questions, feel free to ask.