TS21 holder for IKEA Skadis (T-Clip System)
Miniware TS21 soldering iron holder for IKEA Skadis T-Clip system
4
7
0
85
updated
September 25, 2025
Description
PDFA basic Miniware TS21 soldering iron holder for IKEA Skadis. Bit on the loose side so that if you install the finger grip, it still fits.
It uses the T-Clip locating pin variant, so it shouldn't rotate. Should be used with low profile clips.
I printed in 0.20mm PETG, others should work too. Print upright with no supports.
To install it, first put the T-clip through the clip seat on the model, then put the other side of the T-clip through the hole on your Skadis. Finally, align the part and tighten the T-Clip.
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Uses T-Clip system, ideally with locating pins and low profile clips.
It's based on my parametric trays.
