Unifi G5 bullet junction box mount and G5 Turret Ultra

Mount forUnifi G5 bullet to a Junction Box This works with the included munting screws for the G5 bullet plate .  there is a couple versions with extra holes on the bottem for mounting this was done depending on the angle you want the part mounted at. I just used J-B Weld 8237 PlasticWeld Plastic Repair Epoxy Putty to fill the extra holes .

All printed in ASA

Lid.stl is designed to allow the use of standard junction boxes with the G5 Turret Ultra. The original plate that comes with the junction box is too small to provide enough clearance for the pigtail. While the fit with Lid.stl is snug, it works reliably.

To mount the G5 Turret Ultra, simply attach its mounting plate directly to this printed lid. I didn't model mounting holes into the STL—instead, I manually drilled them as shown in the photos. I’ll upload a clearer photo of the mounted turret soon.

Link to the Junction boxes that were used 
https://www.amazon.com/dp/B0C3W45YNM?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1