Samla chamber 11/22l

I use it for acetone smoothing

print from PETG/PA

DO NOT PRINT FROM PLA/ABS/ASA

floor thingy (for 22l samla) you must cut yourself in slicer

print also clips for lid, as acetone tends to be scared and run away

also beware of condensing of acetone at bottom of a lid and then dropping into your precious prints

BIM: 

4-18x heat set insert M3 (

4-18x M3 bolt

2x 60x60x15 fan

completing:

put fans in place blowing down, fasten as nessessary

i use 5V fans and power bank

module should sit firm in both 11l and 22l samla, if unsure, you can add inserts in holes in wall and bolt it to box