Zephyrus g16 2025 Laptop stand

I made it in a way that will raise the laptop above the mouse pad (~5mm), and the back of the laptop would be above my lamp (~35).
So, technically, there is a ~8-degree rise.

I would suggest printing it without infill and with 3-4 walls.
In my case, each stand is around 25g by weight.

If you want to have infill, without sidewalls, it could be done by the slicer.

V2:
- Fix the cooling suffocation. (Laptop designed to get the air from the sides and blow out at the back. 
- Add the place for the rubber feet. (Glued TPU)
- Added feet and riser 5mm. Just in case. (not tested)

---
Inspired by: https://www.printables.com/model/474397-adjustable-framework-laptop-stand