I made this mount to attach my HomeBase 2 to the underside of my desk.
Note: Version 2 corrects the positioning of the indicator light hole.
This is a friction fit mount, the HomeBase 2 is slanted from top to bottom so this mount matches that angle. It is meant to be installed upside down into the mount prior to screwing it on. There is a hole in the front to allow the indicator light to be visible. The back has a large cutout to allow easy access to the plugs and sync button.
The screw holes are set up for any standard drywall or construction screws.
I printed in PLA at 15% infill with auto trees and outer brim enabled. With these settings it used 98.75 grams and took just under 4 hours to print.
The author marked this model as their own original creation.