Easy print, dovetail mount, Philips OneBlade Wall Mount V2 with hanging pegs

I used a 3D scan of the Philips OneBlade QP2724 from my Miraco Plus to create the handle pocket. The pocket is offset slightly for a perfect fit. The model allows for easy install and removal from the wall, and provides a clean install.

Holds 3 combs, 4 spare blades, an adjustable comb, and has hangers on the bottom for scissors, combs, or other accessories.

6.5" wide. If you need something more compact, please see my original wall mount here: https://www.printables.com/model/1259278-philips-oneblade-wall-mount-and-charging-station-e

Fitment 

Tested with QP2724, QP2520 and QP2834(shown). The QP2834 with usb charging cable works best because the charging cable squeezes down into its cradle and is held securely and positioned perfectly to act as a true dock. The QP2520 cable is looser, so it stays with the trimmer when it’s removed.

Printing:

Pre-oriented. Use organic supports on bed only. 

Your choice of layer heights and material. 
 

I recommend PLA, .15mm layer height, 15% gyroid or triangle infill, and 3 perimeters.

Install:

Mount the plate to the wall using 2X #8 drywall screws, with the stop at the bottom and the slotted feature up.

Slide the Body onto the matching dovetails until it clicks into place. 
 

To remove the body, simply pull the locking tab away from the base plate and lift up.

Thank you for reading, and Happy Printing!

Please remember to leave a like if this model makes your life a bit easier.