Electrolux Tumble Dryer Jockey Pulley

This is a replacement part for the Jockey Pulley, used in Electrolux Tumble Dryers. The slide bearing has been replaced with two commonly used 608zz bearings (skateboard bearings).

Use a filament that withstand some heating as the pulley may be hot on use in the dryer.

Need to be printed with support and a least 3 perimeters.

Post processing:

• Remove support
• Optional: Clear the thin layer covering the center hole
• Optional: Light sand the track where the belt will be running to get smooth surface
• Press fit the two bearings

Shown models is printed in Prusament PC Blend Orange and Devil Design PETG Super Blue.

2024.01.06 Update: Also works with AEG Lavatherm dryers.

>> If you like the model, please leave a like, rating or a make… ;-)