Water diffuser for water hose

Printed in Prusament PLA Prusa Orange (215° and 60°).

Perfect idea and model! The original size fits well.

Works as expected. Nice design. Thks

Very useful. Thanks

This is a piece of art - what a beauty. Print time was Ok. I printed in black PETG in normal mode 0.2 mm. There is some stringing because of the z hopping.

Love this model, was curious what thread pitch/size you made for the threaded version

Very well designed. I have found it to be really useful.

Tnahx for design, works as expected! :)
Retraction paradise :D
ABS 0,2mm

This is a make of version three and it works perfectly. Gardena attachment size is a-okay but benefits from a slight upscale (104%).

Supports are needed along the hose attachment up to the start of the flat body end, but not inside. Printing upside down could eliminate this issue—adding a small solid boss from the round top to the innermost diffuser and creating a flat on the rounded top would allow stable printing and add strength without reducing performance.

Overall 10 out of 10! (edited)

the original had a loose fit so i switched the connector for a biger version