Experimental Phantasm Parts
Description
PDFFlywheel designed to fit Xing 2207 motors. Might also be compatible with T19/Spirit.
Requires good layer & line adhesion to print properly.
Ensure your process can print steep overhangs. (Otherwise wheels will be very unbalanced.) I use 0.24 layer height, 0.48 line width, and 2 walls, 3 top/bottom layers. Concentric patterns w/o infill. Use ABS or other lightweight high temp filaments only.
Not extensively tested in the field yet, has only fired a few darts on a test bench setup. Unknown if the geometry conflicts with the cage.
Firmware contains my adaptations to the hardware I have.
06/17/2025: New updated version has been added, adjusted for weight reduction.
06/18/2025: Modifying this listing to be for all Phantasm edits I do.
Model origin
The author remixed this model.
Differences of the remix compared to the original
Flywheel:
Designed to fit Xing 2207 motors. Might also be compatible with T19/Spirit.
Uses original wheel-dart profile. Adds extra room around motor, requires good layer & line adhesion to print properly. Rest is custom geometry to fit the motor, reduce weight, and for aesthetics.
Firmware:
PhantasmPWMProMini.ino: EXTREMELY EXPERIMENTAL FIRMWARE, USE AT OWN RISK.
Changes from stock PWM/AM32 firmware:
- Pinout changes for Arduino Pro Mini
- Disabled low battery shutoff for testing purposes (eventually I want this to be a warning instead of a forced shutoff, but plan on moving to a new codebase)
- Edited the default profiles to my spec - semi/auto/fast auto, speeds adjusted for 2750kv motors.
- Moved the ESC arming to be just before loop() starts executing, as required by some SimonK ESC's.
