Awesome model! I salvaged some 608 bearings from an old skateboard I had lol. Used #6 and #8 sheet metal screws I had on hand. The #6 fit well but #8 was tight. This is my reminder to order some thread forming screws and bearings
RackRoller: Open Source Flange Roller Add-on For RepBox 2.3.1+ and RepRack System
Open Source Flange Roller Option for RepBox, RepRack or a simple desktop roller solution.
444
1711
43
16 k
updated February 9, 2022
Makes
Comments
Works very well. I was afraid it was gonna be a bit loose on my tubes, as they are 16mm, but it actually fits great. (edited)
Printed great. Works great. I found 1/2" screws to be better to not poke out the other side. Do you have any models that are compatible with these that fit 2 pools side by side into a shared roller? I saw the ones for without the rods.
I decided to use super glue to hold the two parts together, it surprisingly works really well, though I only have one of the two parts for the spool, It sadly doesn't really seem to fit very well at least on my unofficial model of reprack, though with a bit of sanding I have gotten it to fit a little better. Super glue should work as a replacment for the screws as long as you are ok with only using 1kg spools or maybe 2kg spools, though I don't use them. overall amazing model, I'm newer to petg so it had a few defects.
do you need the screws? or could you just use pins to hols the two together, it doesn't really matter if it is held into the reprack as I already have slip rods.
No issues! Printed without support. No clean up needed.
Mcmaster was the easiest place to find and order screws.
Printed on P1S with black Inland PLA. (edited)
