Tablet/phone stand for water rower, less support
This is the Tablet/phone stand by @MikkoManninen_228887 with the top part edited to need less support
2
8
1
71
updated
May 30, 2025
Summary
PDFThis is the Tablet/phone stand by @MikkoManninen_228887 with the top part edited to need less support
Model origin
The author remixed this model.
Differences of the remix compared to the original
A small chamfer was added to the lip that holds the device from sliding off to allow it to be printed without needing supports along the whole length. An additional vertical cross member was added as well to increase compatibility with smaller devices.
Note that the model still likely requires supports in the square hole that interfaces with the bottom part of the stand, unless your printer has very good bridging.