Cable Chain for Sculpfun S30 Pro (and S-models)

Cable and Air hose Management for Sculpfun S30 (Pro, Max) and S-models.

Cable Chain + Gantry Attachment + Rail Support

CABLE CHAIN 30x20

(30x20x40mm and 17x15mm internal)

• CableChain_3020_Start  (1pz)
• CableChain_3020_Link  (As needed for length)
• CableChain_3020_End  (1pz)
• CableChain_3020_Clip  (One for each of the above)

(On my expanded 95x40 Sculpfun S30 Pro, 45 links were needed for the cable chain)

GANTRY ATTACHMENT.

Two versions are provided

• GantryHolder_Merged  - Gantry_holder and Chain_End merged together in one piece.
• GantryHolder  - Can be used with most 3D printed and comertial Cable Chains. (Requires 2 extra M3-8+ screws and nuts)

CABLE CHAIN SUPPORT.

To avoid strain on connectors from Cable Chain’s length and height, and to allow for Rotary use, the Chain runs on a support rail (2020 Frame). You can print it, or you can use a 2020 aluminum profile.

(Since I enlarged the laser area to 95x40, I used the two original side frames for the rail as seen in the pictures)

• Profile_2020_166   - Three Profiles cover the distance between the LegMounts on a standard 40x40 frame (Print Vertically)
• 2020_LegMount   - (Right & Left) They attach to the legs of the laser, and leave enough space for leg Risers when using Rotary.
• 2020_Profile_Connector
  • For joining Printed 2020 profiles in one rail (Print Horizontally)
• 2020_SidebySide_Connector  - (Attaching 2020 Rail to 2020_LegMount)

NOTE:

• As with any printed part, after assembling the chain, flex it for a couple of minutes to improve movement.
• You can use the original frame screws or replace them with M5x18.
• Be careful when tightening the screws! VA screws can easily strip the aluminum threads if overtightened.

Print Settings

Printer:
  Ender 3
Resolution:
  0.2 up to 0.32 (in images Chain printed with CHEP's Hyper Fast 0.32 Cura Profile)
Supports:
  No
Rafts:
  No
Infill:
  10%
Filament:
  PLA, PLA+, PETG

• Edited end chain link to allow for more space on Cable and Air Hose 90 degree exit.
• Holder Gantry added screw holes for non printed Drag Chains and created a merged piece wit Chain End Link.
• Edited no coat 2020 mount legs to make them Thinner and Shorter allowing the use of leg Risers including Atomstack's Round Risers.
• Expanded and Rounded small corners and gaps on all Chain support parts to allow faster printing at Resolutions up to 0.32