Ikea Ivar cable clip

A cable clip that can be stuck in the holes of an Ikea Ivar shelve and will help with cable management. It holds up to 3 cables but you can also stack more than one cable in one clip, so 6 cables are possible

The “two sticks” of the modell have a slightly thinner profile at the end and thicken towards the middle to better stay in the holes. 

Please be aware when printing that there is a top and bottom side.

If you have problems with adhesion to the print bed, I advice to perform a cut of the bottom part of the model in your prefered slicer software. 1 or 2 print layer heights should be sufficient. This way you have more surface area touching the print bed.