Giant Diamond Ring (with stand)

Giant Diamond Ring with Stand

2 Stone Setting Options - Bezel Setting and Tension Setting. I opted to print the Bezel setting because I wasn't absolutely positive that the PLA, at this scale would have enough rigidity to hold the diamond firmly. After printing the Bezel setting I feel that with the right amount of good glue, you could get away with it.

Printed in Eryone Silk PLA Gold 100% size on Prusa Mini+, I was able to fit 2 pieces printed flat minimal supports on the aligner pegs. For best results IMHO, print it as 1 piece printier dependant or print in whatever filament you prefer, use filler on the seams, prime, sand and paint (this Eryone PLA has relatively poor layer adhesion and I have noticed sections that have separated under relatively low mechanical strain).

Use 5mm brim to maximum surface area on the ring components. 10 or 15% infill

Designed to fit 60mm ‘Stone’, I used this one:  https://amzn.to/3JfKkTr

Eryone Silk PLA: https://amzn.to/363fa37