PTFE Tube Clips for K1C Honeycomb Rear Guide

2025/07/09 - I added the vertical mode clip.  Made the clip a bit tighter around the tube.

2025/07/31 - Added v2 - Same clips - Just a little bit stronger.

These PTFE Tube Clips are designed to hold and guide tubing within honeycomb structures like those found on the rear wall of the Creality K1C.

It is for those who want to feed their filament from the any side of the printer. Clips can be set to flow horizontal, vertical or 45 degrees.

Designed to fit the standard 4mm PTFE tubing.

Printing Recommendations

Print with whatever you prefer.  I used PLA.

0.2 Layer Height

2 Walls

15% Infill

No Supports or brims needed.

If you find these clips useful in any way - please consider giving it a LIKE and thanks for printing!