Plant Pot Hose Watering Bracket

Print the model on one side with minimum 0.2 layer height (no supports or brim required) (15% fill). ASA is recommended for outdoor use but PETG or PLA also works. 

Push the bracket onto the edge of a plant pot (or use a stick to plant it in the soil - Ø6mm slot provided in the clip). Secure the clamp part of the bracket to a garden hose with a cable tie. (this design is for a ¾ inch hose but can be scaled). Drill a 6mm diameter hole in the hose. The hole does not need to line up with the bracket opening, a channel in the bracket ensures flow to the opening and turbulence causes a good distribution of the water to the plant pot. The free end of the hose should be blocked.

I setup an automatic plant watering system using these brackets for 20 pots using a water pump setup to a timer.