Newhaven 7 inch display with Raspberry Pi 4B case. Single power cable

Pretty straightforward, can use any cables you wish to but I will link what I used:

Just Print, screw on the Rpi4, snap in the fan, screw in the screen and assemble. Last 4 screws hold it all together.

This was created as an attempt to learn F360 and modeling in general, I hope it helps others.

Parts:

• Newhaven NHD-7.0-HDMI series screen
• Rpi4
• 30mm fan (I used a spare Canakit one laying around)
• 4x M3x6 screws for attaching screen (I used hex head but can use any)
• 4x M3x30 screws for screwing the case together (I used hex head but can use any, hex head will give a nice look on the bottom though)
• 4x M2x6 screws to attach the RPi4
• Short HDMI → HDMI Micro Cable
• Power splitter
• 90 degree USB-C Power dongle
• Beefy Power Supply